Magnetic Tape Loops Construction

 

Constructing Tape Loops For Analog Tape Delays                                                                                                     

 

General                                                                                                                                                                     

 

Making tape loops for your own analog tape delays is not very difficult, you just need to understand the procedure and be gentle as tape loops are very fragile.

 

In the text below I am going to explain in details how you can create tape loops on your own. If you still feel that this is over your skills you can buy them from our us from our Product Section.

 

The tools

For start making your own loops you will some basic tools, there are:

 

* A tape splicer is a special surface that helps you cut and process a magnetic tape easily. You can do the whole procedure without having a tape splicer but the procedure is too difficult, time consuming and I wouldn't recommended us the results are not very good either. You can purchase a professional tape splicer from your Product Section here

 

 An old school  tape Splicer from Scotch

 

Additional information

Please remember to use gloves as if you work without the touch of your hands will affect the quality of the tape loop. Using gloves helps keeping the magnetic surface of the tape clean.

Is also very important to do the whole procedure of construction the tapes on a clear surface with minimum dust as it affects the quality of the products too.

 

Procedure

Step 1

On a clean working surface (probably a table) mark the length of the tape you want to construct, like for example 50 cm. In this way you can cut multiple tapes of the same length easily, avoiding mistakes.

 

Step 2

Tape your tape reel and drag as many tape is needed to cover the distance you previously marked on the table. After reaching this point use the scissor to  cut the tape from the reel. You can do this procedure as many times as the number of the tapes you want to construct.

 

Cut tape on surface

 

Step 3

Take a piece of tape that you previously cut and put one of its sides in the tape splicer. When adjusting it try to exceed a little bit (3 - 4 cm) the middle of the splicer. Remember that the part exceeding the middle will be cut off so we don't want too much tape to get over this point. If you don't take care off this your tape will be too short in the end. So after adjusting the tape correctly, cut it using the inclined cut path. Some splicer tape machines a vertical cutting path, is important not to use this one.

 

       

                                                                                                                 Inserting the tape in the tape splicer

 

 

 

Adjusted tape (one side) in the splicing machine

 

 

After cutting one side of the magnetic tape using inclined cut path

                   

 

Step 4 

Readjust the other side of the tape in the splicing machine and cut by using the same cutting path. Remember to keep the other side of the tape in the tape splicer too.

 

Adjusting the second time of the tape into the splicer

 

 

Tape adjusted and cut into both sides into the splicer

 

 

Step 5

Know is time to connect the two cut parts. For the task you will need some splicing tape ( or some normal tape will do). Cut a small piece of tape like in the picture and press it carefully between the cut parts of the tape like in the photo illustrated below. In this step is very important not to move the cut parts when placing the tape on them. If you do it wrongly the loop will be connected awry, so be careful.

 

 

                                                                                               Tape connecting the two parts of the magnetic tape

 

 

Step 6

Cut the remaining connecting tape in the sides of the magnetic tape by using the special cutting paths of the splicer. Be careful not to damage the tape. Push with your fingers gently the connection tape vertically to make it sit better on the loop.

 

Cutting the edges of the remaining connection tape 

 

 

Step 7

De-attach the tape loop from the splicing machine and your know tape loop is ready. Remember to store it somewhere safely in a dry environment without dust.

   

A tape loop ready for use